JavaScript is required
Türkçe

My RDD6616U automatically starts upon startup

Shane

My cutting machine uses the RDD6616U blade cutting control system. Yesterday, I reconnected some wires, and today it started automatically when turned on. However, I don't know which wires were connected incorrectly. I think this is the reason. Please seek help!

Bu soruyu cevaplayabilir misiniz?

Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.

Cevaplar (2)

  • Matthew
    Kabul Edilen CevapKabul Edilen Cevap

    Did you check if the polarity circuit of the foot switch is reversed?

    1
    Yanıtla
    • You're right, the polarity circuit was reversed, and after modifying the polarity wiring, it returned to normal. Thank you

      0
      Yanıtla
  • This situation is dangerous. Check if all emergency stop buttons are in the released state (popped up). If the emergency stop button is pressed, the system may not initialize properly, resulting in misoperation.

    1
    Yanıtla
    • Okay, thank you for the reminder

      0
      Yanıtla
Chanelink
Chanelink
Chinese 粤ICP备20068671号-3

Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.