Williams
Kabul Edilen Cevap
Kabul Edilen CevapAdjust the focus to the appropriate position, increase the laser power, and adjust the swing length and frequency
1
Yanıtla
I have a breakpoint when using RDWelder-SW laser welding
My control system is RDWelder-SW, but the welding efficiency is not good, with breakpoints and significant laser splashing. What should I do to troubleshoot or optimize? Thank you!
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
I tried increasing the laser power while adjusting the swing amplitude and frequency, and now the welding results are much better.