Darren
Kabul Edilen Cevap
Kabul Edilen CevapSuggest checking the following points:
1. No fan enabled
2. Relay wiring is incorrect
3. Layer setting issue
2
Yanıtla
I am using RDWorksV8 for machining, do not blow air
I am a beginner and have just started working with RDWorksV8. Today, when I was operating the machining, it did not blow air and there was no signal output. What should I do? Thank you in advance for anyone's suggestions.
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
I checked and found that the layer parameters were set to not blow air