Hello everyone! I have a fiber laser cutting machine with a control system of RDC6563FG. During my routine inspection today, I found that there has been a continuous air pressure alarm. Where is the problem? Thank you in advance for any suggestions.
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
Kabul Edilen CevapWhen the motherboard detects that the air pressure alarm input (universal input port I11) is at a low level, the motherboard will generate an air pressure alarm. If it is in processing, the processing will be paused. If further processing is required, please eliminate the alarm fault first before continuing processing, otherwise it will not be possible to continue processing.
Hello! Confirm whether the air compressor or air pump is working properly and whether the air source pressure is sufficient. Check if the air pressure meets the standards required by the equipment (usually within a specified working pressure range). If the air source pressure is insufficient, the air pressure alarm will be frequently triggered.
Benzer bir sorunuz var ama çözüm bulamıyor musunuz? Kendi sorunuzu paylaşın ve topluluktan yardım alın.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
You're right, it's now back to normal