I am a beginner in LightBurn, how can I save drawings in LightBurn? I used to be accustomed to saving the completed cutting drawings, which I could then load and continue using the remaining space for new cutting.

• laser cutting

Simon

6 days ago

397

1

0

I’m new to laser cutting veneer. I still haven’t figured out how to separate the complete line drawing into parts for cutting. I’m working with a line drawing of a flower with 5 petal parts and a center - two leaves with two parts each and a stem with two parts.

• laser cutting

Simon

11-24

514

4

0

I have a Genmitsu 3030 CNC machine with a 5.5W laser installed on it. Overall, it works normally. My question is how to check if the focus is normal? LaserGRBL has a focus setting button. After pressing the button, the laser power will be turned on at 3%. When I observe this butt...

• laser

Simon

11-10

360

3

0

I couldn’t get lightburn to recognize my cutter. I have a Makeblock rotary. Any suggestions?

• LightBurn

Simon

2023-03-17

1K

1

0

Hi guys, I have a Gweike Cloud RF and have had to set my scan off-set in lightburn for 300mm/s at 1.49 mm to remain inside the object I am engraving. This sounds quite a large scan off-set. Can anyone share what off-sets they are using at different speeds. Gweike online help was ...

• LightBurn

Simon

2023-03-15

1.2K

2

0

is there a simple setting for when you rotate text 90 degrees? can i switch the scan direction to move y axis first then the x? when i rotate the text, and there is space between lines, the laser has to travel across those blank spaces just to make one small tick, then move on. s...

• LightBurn

Simon

2023-03-13

986

1

0

I’m running a lengthy cut-thru project with the equivalent of an Atomstack LaserStorm S10 (PerGear branded). BTFW, by lengthy, I mean lengthy. I’ve already had to replace the power supply and upgrade the amperage. I’m about 2/3 of the way thru the project, literally weeks down th...

• diode laser

Simon

2023-02-24

1.1K

2

0

I have a Bridgeport V2XT currently 3 hp intermittent and 2 hp continuous spindle. Got it running on a Mitsubishi FR-720S-100 VFD. Interested in replacing that spindle motor with a 3.7 KW and then having to change the VFD to a bigger Yaskawa so can continue running on single phase...

• motor

Simon

2023-02-22

988

1

0

1、 Torque control The torque control method is to set the external output torque of the motor shaft through the input of external analog quantity or the assignment of direct address. For example, if 10V corresponds to 5Nm, when the external analog quantity is set to 5V, the motor...

• motor
• servo motor

Simon

2022-11-22

1K

0

0