I use a laser on my CNC router. I disassemble the spindle and mount the laser. In this case, a certain offset appears on the laser, which I measured and added to the device setting. Everything is fine when I go to the offset engraving works flawlessly. When I try framing, I have ...

• laser

Rajiv001

04-07

790

5

0

Never used a laser before, I’m trying to make lamacoids with a K40+, but I can’t seem to get the settings dialed in. It leaves some of the material behind… Been trying for 2 days now! The good looking one is my sample, that what I want it to look like. I have the manual power dia...

• laser

Rajiv001

03-19

1.1K

4

0

So I just replaced the tube in my machine and got a wattage tester to confirm its output. After a lot of careful testing, I’m finding that it is maxing out at 110ish watts on a 130 watt tube. Because of this, I’m hoping to find a way to do a system wide power scale so that if for...

• laser cutting

Rajiv001

2024-11-07

879

1

0

I have a J-Tech Photonics 4.2-watt laser. My current value setting is 1000. My question is, what would happen if I increased each setting equally, how would this effect my laser?

• laser

Rajiv001

2024-10-14

981

1

0

I have been installing S9 for a few months now, and a few days ago I decided to give it a try. I returned to my original position, but strangely, the machine got stuck after traveling a few centimeters. I exerted a little force, and it traveled a few more centimeters before locki...

• laser

Rajiv001

2024-10-11

1.1K

2

0

Which is the best choice for water-cooled, air-cooled handheld laser welding or dual circuit refrigerant direct cooled handheld laser welding?

• laser welding

Rajiv001

2023-08-30

1.1K

1

0