Text misaligned using rotary roller

• laser marking

Hiroko

03-03

907

6

0

After a few cuts my brand new laser (Atomstack A10 pro V2 Black) suddenly did not ray (burning / firing), at the same time It is moving properly, fan works, two leds at laser module works (pwm is blue, power is orange). Such bad behavior exists both: under WIFI via Atom Stack Mob...

• laser

Hiroko

02-05

1.2K

8

0

I am sure I am not the only one here that has this happening, most likely with every K40 machine. My machine reaches max output milliamp output at 22-23% output in Lightburn. Would it be possible to calibrate the power output so that it reaches max Milliamp output at 100% in Ligh...

• laser

Hiroko

2024-11-20

1.1K

4

0

Hello, We have a Boss LS 1630 and we are using the Piburn rotary attachment to try and engrave dog bowls. I have been able to use the roller to engrave cups just fine but I have tried to use the chuck for the dog bowls which are much wider in diameter. Rotary mode is turned on, s...

• laser marking

Hiroko

2024-10-31

1.1K

1

0

I fully realize that I may be doing something to cause this, but the biggest frustration I’ve faced is how LB handles layers settings when reopening a project or starting a new one. Because at times, it seems random to me. I’ve had it change for some reason right in the middle of...

• laser

Hiroko

2024-10-21

1K

2

0

I have a ThunderLaser Nova 24. The head goes to the home position after the job has completed. If I am engraving in the bottom of a tray with say one inch sidewalls what would be the best way to instruct the head to stay within the confines of the tray when engraving is complete?...

• laser marking

Hiroko

2024-09-27

1.2K

1

0

The problem of abnormal operation of the reduction motor is mainly caused by issues with the installation plane, bearings, gears, and gear assembly. The specific reasons are as follows: 1. Installation plane issue: Abnormal operation of the deceleration motor may be caused by an...

• motor

Hiroko

2024-08-09

1.1K

0

1

1. Laser cutting machine control software: What are the laser cutting machine control systems? What is control software? The control system and software are related to the material you are cutting. They fall into two categories: metal and nonmetal. Details should be subdivided. ...

• control software
• control system

Hiroko

2022-12-27

1.2K

1

1