Please see image. The text engraved in the right direction but was mirrored.

• laser carving

Narrator

03-20

875

2

0

My svg looks good on the workspace and node edit mode looks good but preview has gaps in the path and actual output matches preview. I have redone the shapes and at first it looked good until I did the preview after moving it to Upper left corner. What should I check? I have go...

• laser

Narrator

03-06

801

2

0

Hi All, I recently updated to v1.7.04 from very old version. I’m setting up a diode laser machine (that was working on that old version) and have upgraded the controller to an MKS SBase I had lying around), running Smoothieware. What happened to the “Laser Control Commands” in D...

• laser

Narrator

01-21

1K

4

0

I discovered after scanning some letters that the “insides” of some letters (think the “bowls” in capital B) were separate from the “outside” of the letters. I know I can Group the two objects (inside and outside) but the grouping can easily (for me) be undone accidentally. It ap...

• laser

Narrator

2024-11-14

765

1

0

Is there a way to change many shapes that are on one layer over to a different layer without having to highlight each one individually?

• laser

Narrator

2024-09-26

837

1

0

1、 Motor burnt out DC brushless motors are not completely fault free, and one common fault is motor burnout. Possible reasons include overvoltage, overload, overheating, etc. If the motor is found to be burnt out, it is necessary to replace the motor and check whether the relevan...

• motor

Narrator

2024-08-09

982

1

1

Electric motors are widely used in manufacturing and household equipment, and it is inevitable that they will malfunction during long-term use. It is important to quickly determine the cause of the malfunction and eliminate it, which is one of the important tasks of equipment mai...

• motor

Narrator

2024-06-05

877

1

0

Many people say that under a certain voltage, the torque and current of a certain motor are directly proportional, and the speed and current are inversely proportional (also inversely proportional to the torque). Are these correct?

• motor
• brushless motor

Narrator

2024-04-27

1.1K

2

0

How does the PLC control the servo motor to automatically move left and right The servo motor drives the linear module to move from the left to the right and then automatically returns

• motor control
• servo motor

Narrator

2023-02-15

888

1

0

1. Controller: used to generate track points, i.e. expected output. 2. Driver: It is used to convert the control signal (usually speed or torque signal) from the motion controller into a current or voltage signal of higher power and output it to the actuator. 3. Actuator: such ...

• laser control

Narrator

2022-12-27

937

1

1