Polski

Nanchang University has made progress in intelligent photoacoustic tomography imaging

396
2024-08-13 15:14:55
Zobacz tłumaczenie

Photoacoustic tomography (PAT) is a novel hybrid medical imaging technique that enables precise imaging of biological tissue structures at different spatial scales. It has been widely used in various fields, including brain imaging, cancer detection, and cardiovascular disease diagnosis. However, due to limitations in data acquisition conditions, photoacoustic tomography systems typically can only collect photoacoustic signals from a limited detection angle, which inevitably leads to a decrease in the image quality of photoacoustic tomography. How to achieve high-quality reconstruction under limited perspective sampling has always been an urgent problem that PAT needs to solve.

Recently, a research team from the Imaging and Visual Representation Laboratory at Nanchang University proposed a high-quality photoacoustic tomography imaging method based on a fractional diffusion model under limited viewing angles. The achievement was published in Photoacoustics, a top journal in the field of optoacoustics, under the title "Score based generative model assisted information compensation for high-quality limited view reconstruction in photoacoustic tomography".

Main research content
The research team proposed a photoacoustic tomography reconstruction method based on the fractional diffusion model. During the training phase, the model learns the data distribution of the samples by gradually adding noise to the existing samples. In the reconstruction stage, this method uses the prior information about image reconstruction learned by the diffusion model as the regularization term in the iterative reconstruction algorithm, and through cyclic iteration, high-quality photoacoustic tomography imaging under limited viewing angles can be achieved.

Figure 1. Process diagram of PAT reconstruction based on diffusion model method from a limited perspective.

As a validation, the research team evaluated the performance of the proposed method using experimental data from circular phantoms and live mice. In the circular phantom reconstruction experiment, this method was compared with traditional delay summation method (DAS), gradient descent method without regularization term (GD), gradient descent method with Tikhonov regularization term, U-Net method, and GAN method. The results are shown in Figure 2. The proposed method shows higher quality and clearer contours in the reconstruction results under different limited viewing angles. At a limited viewing angle of 70 °, the proposed method achieved peak signal-to-noise ratio (PSNR) and structural similarity (SSIM) of 31.57dB and 0.95, respectively, which were improved by 203% and 48% compared to the delay summation method.

Figure 2. Reconstruction results of circular phantom.
From the experimental results of the simulated small balls and live mice (experimental data), it can be seen that this method still has good performance (Figure 3). Specifically, in extremely limited detection angles (such as a 90 ° limited angle), this method outperforms the U-Net method significantly. In live mouse experiments, this method achieved an SSIM/PSNR of 0.80/29.18 dB in reconstructed images with a limited viewing angle of 90 °. Compared to the U-Net method, the PSNR increased by 64% and the SSIM increased by 48%.

Figure 3. Reconstruction results of live data from different detection perspectives.

Conclusion and Prospect
This study proposes a new high-quality photoacoustic tomography imaging strategy based on the fractional diffusion model under limited viewing angles. This method combines the physical model of PAT with the diffusion model, and introduces high-dimensional prior information learned by the diffusion model deep network in the model-based iteration process. This method significantly improves the imaging quality and effectively solves the problem of image quality degradation caused by limited viewing angle sampling in PAT, with the potential to accelerate PAT imaging speed and expand its application range.

Guo Kangjun, master's student Zheng Zhiyuan, master's student Zhong Wenhua, and master's student Li Zilong from Nanchang University are co first authors of the article. Professor Liu Qiegen and Associate Professor Song Xianlin are co corresponding authors. This study was supported by the National Natural Science Foundation of China and the Key Research and Development Project of Jiangxi Province.

Source: Opticsky

Powiązane rekomendacje
  • Fraunhofer ISE develops a faster laser system for wafer processing

    By using a new type of laser, the processing speed of wafers can be 10 to 20 times faster than before. This is the result of a research project at the Fraunhofer Institute for Solar Systems in Germany.Researchers have developed a prototype that can use ultraviolet waves to carve the most intricate structures on silicon wafers. The new system concept enables solar cell manufacturers to perform lase...

    2023-12-23
    Zobacz tłumaczenie
  • Luxiner launches LXR ultra short pulse laser platform

    Luxiner, the global leader in laser technology, has launched LXR ® The ultra short pulse (USP) laser platform is a revolutionary leap in industrial laser processing. The LXR platform provides unparalleled performance, versatility, and reliability, making significant progress in burst mode processing. Micro Miracle MasterThe world of miniaturization is flourishing due to the continuous improvemen...

    2024-06-11
    Zobacz tłumaczenie
  • Han's Laser New Product Debuts at 2025 Munich Shanghai Light Expo

    New product launch of "Blue Hurricane" red blue integrated laser1. Ultra high power: The "red blue integrated" laser, with optimized optical path design and heat dissipation system, can stably output power exceeding industry standards, meeting high demand application scenarios.2. Dual high brightness: Integrating advanced wavelength modulation technology and materials science, both red and blue l...

    03-07
    Zobacz tłumaczenie
  • Beijing Institute of Technology has made significant progress in the study of ultrafast carrier dynamics in optoelectronic functional crystals

    Recently, teachers and students from the Institute of Solid State Laser and Ultrafast Photonics at the School of Physics and Optoelectronic Engineering have made significant progress in the study of ultrafast carrier dynamics in optoelectronic functional crystals. The related research results are titled "Anisotropic carrier dynamics and laser fabricated luminosity patterns on oriented single cryst...

    2024-02-21
    Zobacz tłumaczenie
  • The INRS camera captures transient events and is suitable for various scenarios such as high-speed LiDAR systems for autonomous driving

    It is reported that the National Institutes of Sciences (INRS) of Canada has developed a camera platform that can achieve cheaper ultra fast imaging through the use of ready-made components, which can be used in various applications.This new device aims to address some of the limitations of current high-speed imaging, including parallax errors and potential damage from pulse illumination. Th...

    2023-10-07
    Zobacz tłumaczenie