CO2 laser gets weaker above 50%

Miller

Categorieën:

激光

Tags:

CO2 laser
laser cutting

Bekijk vertaling

2023-02-27

My 40-50W co2 laser cuts 1/4" plywood and acrylic well at 50% but above 50%, the cuts get shallower as I increase the power. The current stays approximately proportional to the power setting, but the beam seems to get weeker. Is this normal or a sign of a partucular failure?
The tube has less than 100 cutting hours, mostly at about 45%. I almost never run above 15mA current.
The tube is a TONGLI 40-50W Co2 Laser Tube
35-50W CO2 MYJG Serise Power Supply MYJG-40 OG 110/220V × 1

Cyril

2023-02-28

Check if your laser mirror alignment is spot-on. It could be that when you increase the power, that the beam gets reflected within the side of the laser head tube and is not 100% leaving your laser head. If you increase the power, thus the tube (at the laser head) getting warm/hot?

Bekijk vertaling

Antwoord

Relevante aanbevelingen