chanelink logo
CHANELINK
Nederlands

10w Elegoo Phecda can not cut 1mm cardboard

Categorieën:
원자 램프
Tags:
381
1
Bekijk vertaling
2023-12-14

I am new in lightburn and diode lasers yet i owned a 10 watt elegoo phecda laser and set in with the lightburn. watched all the videos and checked all the parameters, focusing done and i am using full air asist with the honeycomb. where i am doing wrong that i can barely cut a 1mm cardboard with 100 mm per minute and 100 percent power with the material test results coming over and over in same. need help or anything that i am missing
C

    • Patrick

      2023-12-15
      Check that the value of S Value Max in Edit->Device Settings matches the value of $30 in Edit->Machine Settings.
Other than that, make absolutely sure that the units is mm/min for your speed.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren