Can the cw3000 water cooler be used for the 150 watt laser?
2022-12-301K10Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y and I can't figure it out for the life of me
2022-12-281.3K10It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?
2023-01-091.1K10It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.
2023-01-0698110The border running is normal, but the click to start does not respond.
2023-01-061.1K10Does anyone know?
2023-01-091.1K10I am not familiar with the software, how to set the starting point and direction of cutting?
2023-01-051.3K1001Ensure the normal operation of the laserTry to ensure that the ambient temperature is not lower than 5 ℃, so as to meet the normal operating conditions of the laser, and avoid causing failures or affecting the stability of the laser performance. Avoid the laser water cooler from freezing at low temperature.1. The recommended method to prevent ...
2022-12-261.2K11Influence of galvanometer frequency of laser derusting motor on laser
2023-01-061K10Can someone tell me how to operate it?
2023-01-0694910How to check the quality of metal laser cutting? See the following nine standards.1. RoughnessThe laser cutting section will form vertical lines. The depth of the lines determines the roughness of the cutting surface. The shallower the lines, the smoother the cutting section. Roughness not only affects the appearance of edges, but also affe...
2023-01-041K00During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.
2022-12-301K11Switch to the manual state, press the Z+and Z - buttons on the operation panel, and the Z-axis motor will not move.
2022-12-301.4K21
- データがありません
日本語
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski