My handheld laser welding system is RDWelder DW-V2Pro. Although the equipment can start normally, the laser output is significantly abnormal and the energy is significantly reduced compared to before....

• galvo scanner
• beam delivery system
• RDWelderDW-V2Pro
• laser welding
• RuiDa

Today, I used CO2 laser cutting equipment to process workpieces. The control system is RDC8445S. After starting, the cutting head ran normally, but there were obvious uncut areas on the edges of the c...

• galvo scanner
• beam delivery system
• RDC8445S
• laser head
• RuiDa

I tried to seek help in this community by starting a laser handheld welding machine equipped with an RDWelder-SW controller. The parameters were not changed, and the gas and water cooling were also no...

• galvo scanner
• beam delivery system
• RDWelder-SW
• laser welding
• RuiDa

Excuse me, I have a new question. When using RDWorksV8, I found that the slope effect is not obvious in scanning mode. Originally, I should be able to see a clear slope transition effect during the ca...

• galvo scanner
• RDWorksV8
• laser engraving
• RuiDa

When using the RDC8445S controller for scanning, I found that the scanning results always showed ghosting. I checked the controller settings, adjusted the resolution and scanning speed, but the proble...

• galvo scanner
• RDC8445S
• control system
• CO₂ laser
• RuiDa

I used the RDC8445S control system for carving and found that the bottom of the carving was uneven. After careful inspection, I found that this problem occurred in different areas, especially in large...

• galvo scanner
• assist gas system
• beam delivery system
• RDC8445S
• RuiDa

My handheld welding machine has been in use for several months now. It uses the RDWelder DW-V2Pro control system. Today, while performing routine operations as usual, I noticed the laser output is ver...

• galvo scanner
• beam delivery system
• RDWelderDW-V2Pro
• laser welding
• RuiDa