chanelink logo
CHANELINK
Italiano

Settings for neje 4max

Categorie:
Laser
Tag:
812
1
Vedi traduzione
2023-08-24

If I try to start the laser He always Go Up first and than start .
So he runs against the switch and lost the steps he need. look pic.

Can Anyone Help me whit this
C

    • Tory

      2023-08-25
      What are you expecting to happen?
I suspect you have either a material height set or a Z-offset configured on your layer.
If you want no movement then trying the following:
1. In Edit->Device Settings enable “Relative Z Moves Only”
2. Remote any Z-offset in Cut Settings
        Vedi traduzione
        Rispondi
      Raccomandazioni pertinenti
      Raccogli
      Segnala