Probably missing steps doing small lines?
Catégories:
Laser
262
1
0
2023-06-20
C
Liam
2023-06-21I can’t see the units in your Cut settings but I’ll assume you’re running mm/s. If true, that would make your speed settings quite fast. In fact, likely faster than your machine is currently equipped to move. If your machine is typical it likely has a max speed of 300 mm/s. Try lowering your speed settings well under that to see if anything changes.
0Répondre
Recommandations pertinentes
-
How to reverse filling
2 Réponses03-01 - 2023-05-25
- 2023-05-29
- 2023-03-28