chanelink logo
CHANELINK
Français

Change settings in mid burn

Catégories:
レーザ
Tags:
493
1
Voir la traduction
2023-03-18

Hi can settings be changed and saved during the burn. I would like to change the number of passes on a particular layer that is being engraved. Or would I have to wait till current layer is done then start from the beginning again then go over it
Thanks
C

    • Abel

      2023-03-20
      I think if you have the console open, it switches to allow you to control the speed and power values with sliders within a certain range…

You would have to note them for entry later, I don’t think they are saved anywhere… It also works in percentage… if I remember correctly…
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport