How to adjust the step distance of Axis Z.
              Categorías:
              
  Ruida
                823
              
 
                1
              
 
                0
              
 
              2022-12-15
            
C
- Snow Sun 2022-12-16- Step length for Z is a little bit difficult for users to measure. normally you can use a ruler to test that. only check the nozzle distance from the work table! 0Responder
          Recomendaciones relevantes
        
 -  03-28
-  RDC6332G Fan control4 Respuestas2024-01-15
-  2024-02-15
-  password factory settings RDC8445S?2 Respuestas09-02
-  When opening the software, it prompts "PCI card reset failed!" Or "Reset PCI card failed"1 Respuesta2022-12-06


 
  
  
  
  
 