The solenoid valve of OUT2 and Wind connected to 2W80MA does not work
Categorías:
Ruida
969
1
0
2022-11-29
C
Miller
2022-12-02Cause analysis: The coil current of the solenoid valve is too high, which breaks down the Q3 diode of the board Solution: It is recommended to use 24V relay and replace diode
0Responder
Recomendaciones relevantes
-
RDC6442 stuck at connecting to controller
2 Respuestas2023-02-15 - 2024-02-15
-
Dual outputs for Lasers
1 Respuesta07-21 -
Ghost appears in scanning
1 Respuesta2022-12-13 - 2022-12-08
