chanelink logo
CHANELINK
Ελληνικά

RDC6563FG

Κατηγορίες:
Ruida
906
5
Δείτε τη μετάφραση
02-26
Hello.
I have RDC 6563FG, laser MAX 1500, BM-110 head and two X-Y axes.
I need to place the metal plate at a distance of more than 30 mm from the nozzle and process it with a defocused laser beam.
Is it possible to disable the use of the capacitive sensor and not monitor the gap between the metal plate and the nozzle? Otherwise, the message appears - <too small cap>.
C

    • blue sea

      02-28
      Hello! You can choose not to follow in the layer settings to disable it.
        Δείτε τη μετάφραση
        Απάντηση

      • A56F72A7

        02-28
        In this case, the graphics are processed without turning on the laser radiation.
          Δείτε τη μετάφραση
          Απάντηση

        • A56F72A7

          03-04
          The issue is resolved. The shutter had to be pressed before the start
            Δείτε τη μετάφραση
            Απάντηση

          • A56F72A7

            03-06
            One more question. Why is the "Machine Check" button not active in RdCutist v3.0?
              Δείτε τη μετάφραση
              Απάντηση
              • blue sea

                : Hello, this function is not yet open for use, the software is constantly being tested and optimized, please pay attention to the latest notice on our official website in the future, thank you for your support and use!

            Σχετικές συστάσεις
            Συλλογή
            Αναφορά