chanelink logo
CHANELINK
Ελληνικά

AtomStack X7 cut settings

Κατηγορίες:
レーザ
Ετικέτες:
852
1
Δείτε τη μετάφραση
2023-05-12

I just received my X7 and am trying to figure out what the best setting are on LightBurn for cutting 7oz leather.
I had it set up at 5mm/s at 100% for 5 passes. The outer cut for a keychain was fine, but when I had it cut for the key ring hole it seemed to melt the top half of the hole. If I speed it up, it doesn’t cut all the way through. Just seeing if anyone has any insight for this engraver.

 
C

    • Abel

      2023-05-13
      I am not sure, but i think there is some settings you can select on lightburn cut/engrave properties precisely to avoid that issue.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά