Alarm 6, the stepper is stuck and unable to move. Is the stepper broken?
hello
i havent used my 3018 in a while and am wondering what im doing wrong. i’m all set up wit grbl and lightburn 1.7.03 I power up and it begins to home motors just stuttuer terribly and wont move.however if I run under focus test the hardware seems fine. thank you
i havent used my 3018 in a while and am wondering what im doing wrong. i’m all set up wit grbl and lightburn 1.7.03 I power up and it begins to home motors just stuttuer terribly and wont move.however if I run under focus test the hardware seems fine. thank you
Was halten Sie von diesem Beitrag? Teilen Sie Ihre Gedanken in den Kommentaren.
Probably the homing speed is much too high, so the motors can’t keep up with the pulses. Reduce $24 (and maybe $25) by a factor of ten and see if that improves the results. The maximum speeds & accelerations may be too high for the machine. Make sure $110-111 and %120-121 makes sense and reduce them as needed.