Preview doesn't remember reverse selection

2024-10-24

I have a project where I have two images, one is inverted, the other not. When I do a Preview I do not want it to be inverted so I deselect it. However, when I go back out, make a few changes and do another Preview, it is back to selecting ‘Invert’. It would be better I think to remember the user’s selection of whether he/she wants to Invert the preview or not.

Laser

Comments (3)

Payson
Report
if you preview an image that is inverted, it inverts the preview for you to match. In most cases this is the “correct” behavior.
2024-10-25
0
Reply
- LWE
  Author
  Report
  Thanks, that’s exactly what I thought was happening, is there any way you can get it to ‘remember’ the last Preview you did?
  2024-10-26
  0
  Reply
- PaysonreplyLWE
  Report
  Not at this time, no. It will remember if there are no images, but if it sees an inverted image it will invert the preview.
  2024-10-28
  0
  Reply