chanelink logo
CHANELINK
繁体中文

PSU and Reci compatability advice

分類:
Laser
標簽:
699
1
查看翻譯
2023-02-24

I have a 100w reci laser with a JYJG 80w PSU(came with the machine when I bought it). I think PSU is fried now and I have to replace it. I know it was undersized but I rarely used the laser anywhere near full power which I presume is why it lasted 4 years.

 

On the machine I mostly engrave wood and cut sandpaper so my 100w reci is oversized. I only really need the Reci W1 75watt. My current 100w reci is 4 years old so i presume its near the end of its life so when it is, I will downsize to the 75watt W1 reci.

 

Id like to get a decent PSU to replace the cheap chinese crap i have now. Im looking at Cloudray as they seem a trustworthy site from China. Im in EU. W&Z&Es Series – Cloudray Laser

 

Am I right in thinking the Cloudray 80-100W HY-Z would be compatablie for both the W1 75w reci and the W2 100w? This would be ideal as then I wont need to buy different power supply when my existing tube dies and I downgrade to the 75w. Or am I better getting the 100-120watt PSU? Any advice as to what is best to do?

 

 
C

    • Jen

      2023-02-27
      Check the output voltages. The PSU must always be stronger than the tube, doesn’t matter if you don’t run it at partial power. Using the 80W supply on a 100W tube means you most likely cooked the flyback transformers. Some 80W PSU’s will handle a good quality 90W tube, but barely. The 100W was out of it’s range.
        查看翻譯
        回複
      相關推薦
      收藏
      舉報