RDC6445G Tri-color Lamp

Keith23

分類:

睿達

753

查看翻譯

2023-06-07

Hi all,

I've just completed building a 600mm x 400mm 90w machine with an RDC6445G controller.

I noticed (in the manual) that a tri-color warning lamp can be connected to the controller but I'm unsure how to do this. I did see a video on YouTube where a single lamp was connected to the 'Status' pin but I would like a three-color lamp (as shown in the manual). How does this connect to the controller?

blue sea

2023-06-08

Hello, you can connect the STA port to the green light, the OUT1 port to the yellow light, the OUT2 port to the red light to connect, thank you for your support of Ruida products!

查看翻譯

回複

RDC6445G Tri-color Lamp

The circular cutting is not closed, the straight line is not straight, the XY axis jitters

During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.

Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y

Vibrating knife cutting pattern is not closed.

The tool lift coordinate is set, but the tool is still lifted to the zero point coordinate during the cutting process.