How do I organize this vertically and horizontally

Williams

分類:

Λέιζερ

標簽:

LightBurn

575

查看翻譯

2023-06-05

I’m working on a guitar fretboard. Usually the fret dots go in the middle of the fret board, which is easy to figure out in lightburn. But for this particular board I want the fret dots to be dead center on the left half between the edge of the fretboard and the center line. And also dead center between the two frets. Any ideas?

Payson

2023-06-06

Create the temporary geometry you need, snap the circle to the center of it, and delete the geometry. An X from the two corners of the area in which the Dot is to be centered, should do.
Yes?

查看翻譯

回複

How do I organize this vertically and horizontally

Trying to find info on a Bodor Laser 80w machine, model BCL 0605MUF

TwoTrees TTS-55 Connection Issues with Lighburn GRBL

Problem mitder Gravur (problem with the engraving)

Rotating 22.5 degrees?

Enlarge space between cut paths