I am planning to order a fiber laser marking/engraving machine. Almost done. It will be MOPA M7 100 W E2 source from JPT. Now the lenses: quartz material and i decided to take 4 lenses. My current pick is F100, F210, F290 and F420. What you think about this set? I’m buying this l...

• Laser marking
• Laser engraving

Iron Man

04-21

1.5K

3

1

What would suddenly cause the camera to be about 2 inches off in the Y axis? I was using the camera for a few cuts to salvage some scrap and it was working perfectly as usual then from one set up to the next, it framed two inches higher in the Y axis than showed in the picture, T...

• Laser

Iron Man

02-13

826

2

0

Moving with the keypad either works fine, or doesn’t work at all. I feel like I must be missing something that enables it, but I haven’t found it yet. Any clues?  

• Laser

Iron Man

2024-09-25

987

1

0

Double speed chain transmission is a mechanical transmission device used for transmitting power and motion, mainly used for producing or transporting various materials through transmission. Of course, the main methods of double speed chain transmission include efficiency, reliabi...

• chain drive

Iron Man

2024-05-15

974

1

0

The E05 fault code alarm of the chiller (cold water tank) is usually caused by abnormal water flow rate, and there are usually the following reasons: 1. Check if the circulating water in the laser water cooler is fully filled and if there is dust blocking the bottom filter scree...

• Hydrocooling

Iron Man

2024-04-27

1K

1

0

1. The Martensite on the top of the laser cladding layer shows a finer and more uniform granular structure. 2. The martensite at the bottom of Martensite formed by laser cladding layer is thicker and uneven.

• Laser

Iron Man

2023-07-12

1.1K

1

0