RDD6584G control system punch does not rotate
I found that the punch cannot rotate while operating the RDD6584G control system. The system is powered on normally and there are no alarms on the display interface, but the punch does not respond after starting the command. Checked the power lines, control signals, and mechanical connections, and found no abnormalities. The drive module also did not display any faults. Do you have any suggestions for this?
你能回答这个问题吗？
请写下你的答案，帮助遇到同样问题的用户。
回答（2）
1. Check if the power supply of the punch motor is properly connected. Confirm that the power switch has been turned on and whether the power voltage is within the normal range.
2. Check if the electrical connections between the punch motor and the control system are secure, free from looseness, poor contact, or disconnection.
3. If the punch motor uses a stepper motor or servo motor, check if the drive signal of the motor is correct.2回复
Okay