Speed and laser power settings
My computer crashed while engraving earlier. Image had a 1 hour 15 minute time estimate. Same engraving this morning was close to that estimate. Trying to burn image this afternoon, estimate is not 1 hour 40 minutes. Laser head doesn’t change speeds when changing settings while doing test burns.
Any ideas on what setting(s) need to looked at?
你对这篇帖子有什么看法？欢迎在评论区分享。
The preview estimates gets the data to compute this from Might try Edit → Device Settings → Additional Settings Then click on Read From Controller This will read the machines values… it’s possible they haven’t been updated