Overscanning and zero position

\n\n\n\n\n\n\nAlso, we’ve seen that for engraving at high speeds we\nare having a big overscaning each side of the job. We are working with servo\nmotors, but even putting the acceleration to the maximum value (100000mm/s2), for 2000mm/s we have an\noverscanning of 50mm each\nside, and 60mm if we\nhave the reverse compensation settings adjusted. This means we loose 120mm of the X travel. Is there any\npossibility to reduce this? If we want to have a table with rulers with a 0 point,\nwe need to set this point at a position where we can engrave from there\nwhatever it is the speed we are working, this means we will loose 120mm of the X axis travel.