6563F moves manually on the panel according to Z-axis, and the cutting head does not move.

Analysis and troubleshooting:
① The wiring of the servo driver is incorrect.
② The servo driver parameters are not set correctly.
③ The servo driver does not support speed control mode.
④ The Z-axis of the mainboard gives an alarm, causing the movement to stop.
⑤ The connection between the panel and the motherboard is abnormal.

• Jamie

  : Solution: ① Refer to the relevant wiring instructions in the user manual for correct wiring. ② Set the parameters correctly according to the instructions of the servo driver. ③ Please select a drive that supports speed control mode. ④ Eliminate the alarm fault according to the alarm prompt on the panel interface. ⑤ Check whether the panel connecting line is firm, and the Z-axis movement can be controlled through PC.