The bottom of the scanned figure is uneven
分类:
Ruida
595
1
0
2022-12-09
C
Tory
2022-12-10Cause analysis: Incorrect parameter setting Solution: Re adjust the scanning parameters Scanning mode: if the special mode is enabled, the laser power should be increased. The lower the spot percentage, the more the laser power attenuation To achieve the same scanning depth, the set laser power should be higher. The purpose of selecting a special mode is to make the laser emit light in a short time with high power, and achieve a flat bottom effect during depth scanning.
0回复
相关推荐
- 06-23
- 2022-12-15
-
RDC6332G Fan control
4条回复2024-01-15