chanelink logo
CHANELINK
简体中文

See power at a given point in grayscale

分类:
激光
标签:
186
2
查看翻译
2024-01-11

Hello everyone,
I’m trying to engrave using grayscale mode, I have a hard time figuring out which part is at full power, which part are in a small power.
Is there a way to see the power it will engrave at a given point before launching the engraving ?
Regards.
C

    • Cyril

      2024-01-12
      If you enable “Shade according to power” in Preview, it will show you the relative power differences in the engraving based on grayscale value. However, I don’t believe this shows you the absolute power level that will be used to engrave after translation to Max and Min power levels.
        查看翻译
        回复

      • jay

        2024-01-22
        goods?
          查看翻译
          回复
        相关推荐
        收藏
        举报