Problem with height sensor and Z axis

hqEbIakv

分类:

睿达

454

查看翻译

2023-10-19

Hi everyone!
Please help with RDC6563FG controller
Heught senson has no effect in HMI panel, if i chorted nozzle to earth, i dont see the alarm in controller
I bought a new one aplifier, and this sensor dont worked too
And axis Z has not moving any way, i checked up to PIN8(DA) in Z axis motor interface, and i have only 0v in this pin. Any ideas how a can make my machine is worked?
Controller is new, bot seller dont reply and dont read my messages

blue sea

2023-10-20

Hello! First determine if the wiring definition of the new amplifier is different from the old one? If not, you need to rewire according to the definition. If it is the same, you need to make contact between the nozzle and the material to see if the capacitance value changes, and is there a problem with the induction wire connecting the nozzle?

查看翻译

Problem with height sensor and Z axis

After cross cutting correction, the cross cutting is not aligned, and there is still offset

RDC6563FG

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov

Controller Fault?

I am not familiar with the software, how to set the starting point and direction of cutting?