AtomStack X7 cut settings

Kevin

分类:

激光

标签:

LightBurn

846

查看翻译

2023-05-12

I just received my X7 and am trying to figure out what the best setting are on LightBurn for cutting 7oz leather.
I had it set up at 5mm/s at 100% for 5 passes. The outer cut for a keychain was fine, but when I had it cut for the key ring hole it seemed to melt the top half of the hole. If I speed it up, it doesn’t cut all the way through. Just seeing if anyone has any insight for this engraver.

Abel

2023-05-13

I am not sure, but i think there is some settings you can select on lightburn cut/engrave properties precisely to avoid that issue.

查看翻译

AtomStack X7 cut settings

Drag and Drop not workling in win 10

New nano composite film enhances heat dissipation of thin electronic materials

Zhixiang Optoelectronics completed a new round of strategic financing focusing on high-precision 3D vision technology innovation

Suzhou mill photonics "laser cutting equipment and its gas circuit rectification

Factors affecting the surface quality of laser cladding and improvement measures