chanelink logo
CHANELINK
Tiếng Việt

Laser cutting of acrylic with rough edges

Danh mục:
Láser
Thẻ:
350
1
Xem bản dịch
09-29
Hello, I am cutting extruded acrylic and the edges are very rough and appear to have little bubbles through out it. I've cut this stuff before with a great flame polished finish. Any advice on why this is happening?
C

    • Williams

      09-30
      Have you tried lowering the amount of air assist you are using? Too much and it will cool the cutting zone.
        Xem bản dịch
        Trả lời
      Đề xuất liên quan
      Thu thập
      Báo cáo