chanelink logo
CHANELINK
Tiếng Việt

Preview and output do not match SVG

Danh mục:
Tia laze
430
2
Xem bản dịch
03-04

My svg looks good on the workspace and node edit mode looks good but preview has gaps in the path and actual output matches preview.

laser

I have redone the shapes and at first it looked good until I did the preview after moving it to Upper left corner.
What should I check?

I have gone back and now find that the loss occured when I put the output on layer 2. The output and preview look good on all layers except layer two. Very puzzling.
C

    • Jamie

      03-05
      Make sure that tabs are off
      Xem bản dịch
      Trả lời

    • Keegan

      03-06
      It is possible when you selected the lines for assigning them to CO2, you might have missed some of them.
        Xem bản dịch
        Trả lời
      Đề xuất liên quan
      Thu thập
      Báo cáo