Atomstack Camera Alignment complete failure

Was the camera alignment calibrated at the height of the material? If not, that could be a factor in the misalignment.
The alignment is only going to be good for the original distance that the alignment was done.
However, this looks a bit more than could be explained with that.

You have a couple of options:
1. rerun camera alignment. You may want to also rerun lens calibration if you didn’t get stellar scores. I can’t tell from the images whether or not you’re having a lot of distortion. If you do, then rerun lens calibration.
2. Use the Width/Height and XY Shift controls to adjust the position of the overlay relative to the design. You may be within tolerance for that to work well enough. Remember to save the changes or else you’ll lose them when you shutdown.