Sculptfun S30 Ultra Fan Issue

jessie

Danh mục:

Tia laze

Thẻ:

LightBurn

645

Xem bản dịch

2023-10-16

Hello,

I have just cleaned my laser top to bottom but I can’t figure out where this plug is supposed to go. It is a part of the air assist fan, but I don’t see a port for it to plug into.It is a tiny white plug that is on the brushless DC fan. Please help!

Liam

2023-10-17

The fan is connected to the control board of the laser. Since this board is now mounted inside the module, you need to remove the control board as well. There are screws at the back to hold the control board. It won’t be that easy to assemble it again. Maybe next time try to keep the fan connected.

Xem bản dịch

Trả lời

Đề xuất liên quan