New user with rotary issues

Liam

Danh mục:

Tia laze

Thẻ:

LightBurn

944

Xem bản dịch

2023-08-04

I recently purchased a k40 laser with the primary intent of engraving on wood pens that I make.
I upgraded the control board to a Mini Gerbil 3 so that I can use Lightburn software. I have been around with the software and I kinda have the basics of engraving and cutting.

Included in the K40 purchase was a chuck style rotary attachment. The guy didn’t recall where he got it from or anything about it other than he intended to engrave pens with it but never got around to trying it. When I plug the rotary attachment connector into the Y axis connector of the Mini Gerbil 3 and have the laser HOME the laser head goes to the x axis limit switch and the rotary spins in the correct direction a few times and I get a message that the machine could not locate the limit switch.

If I try to move the laser after that I get an error 9 message.

When I go into the rotary setup screen and select a chuck type rotary device I have no idea when setting to use since I don’t have any information on the rotary device.

I have searched all over for info on this device to no avail. It has no marking on it other the name and model number on the stepper motor. The stepper motor is a USONGSHINE US-17HS4401

I would greatly appreciate If anyone could shed some light on this!
Maybe I’m wrong but I assume I need something like this rotary device to engrave on round pens.

Jamie

2023-08-05

"When I plug the rotary attachment … the laser HOME … rotary spins in the correct direction a few times … could not locate the limit switch."

Working like it’s supposed to be.
You have no home switches on the rotary, so it cannot complete the home function…
The rotary is 3d printed, so I doubt you’ll find anything on it… The motor is a NEMA 17.
Homing is enable by $22=1, $22=0 disables homing.
I’d start with the 360mm/rotation and see what it does. You have to turn off homing if you are connecting then powering back up.
Using the test button in the rotary gui, it should drive the chuck 1 complete turn and back.
You can also watch the motor shaft itself, find the right numbers and apply the gear ratio to that value for a good entry.
I have a different machine settings file for different rotaries… a chuck is different from a wheeled rotary, at least speed wise…
Good luck

Xem bản dịch

Trả lời

Đề xuất liên quan