Kerf vs. Wattage

Smith

Danh mục:

Tia laze

Thẻ:

LightBurn

1.1K

Xem bản dịch

2023-06-07

Is there a relationship between wattage capacity and kerf?

Situation: I currently have a 5W Sculpfun, and I’m considering a purchase of a 10W or 20W diode (possibly a Roly LaserMatic; would love feedback on this unit as well, if anyone has one). My 5W unit has been well-tuned and some parts upgraded, so it’s quite good at what it does, especially photos. Very fine pitch.

One application I’m using this for requires a very tight kerf, but I need more speed (don’t we all?), so I’m wondering if, let’s say I get a 20W, if that will likely expand my kerf. Related; is it wattage used or wattage capacity that matters? i.e. If you have a 20W laser, but run it at 5W, will that alter the kerf?

I expect that some of this depends on the specific laser module and/or the brand, but I’m looking to understand the general physics. We can talk about kerf for different brand lasers as well, but I suspect a lot of the diode lasers modules themselves are very similar.

Thanks.

Terrelle

2023-06-08

The kerf is determined by the size and shape of the beam at focus. That aspect should be independent of power, but with a catch. Higher power with the same beam size can burn a wider swatch due to the extra heat. If you speed up the travel, you reduce this overburn effect. I found the Roly Lasermatic10 advertises an .08mm x.08mm beam. The Genmitsu Jinsoku LC-40 (10w) advertises a .08mm x.06mm dot (not said which axis was .06mm), so the kerf is likely to be different between the X and Y axis. I expect a round dot is better than an oval one.

A 5.5w laser uses about 40 watts of power. Manufacturers play games with the advertising, so read the info carefully. Laser output power is what I focus on. Also remember 5.5w is about the most you can get out of a single diode. Multiples of 5 are obtained using more diodes, which all have to be focused to the same exact point. The more complicated the machinery, the easier it is to gum up the works.

Xem bản dịch

Trả lời

Đề xuất liên quan