G-Code Motion Target Exceeded GRBL Win 10 / Lightburn

Smith

Danh mục:

Λέιζερ

Thẻ:

LightBurn

530

Xem bản dịch

2023-06-05

What is causing this?
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
$X
[MSG:Caution: Unlocked]
ok
Waiting for connection…
ok
[VER:1.1f.20180715:]
[OPT:VMZ,35,254]
Target buffer size found
ok
Homing
ok
<Idle|WPos:0.000,0.000,0.000|FS:0,0|WCO:0.000,0.000,0.000>
ok
Starting stream
ALARM:2
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)
On or near line 2:
Stream completed in 0:00
[MSG:Reset to continue]
ok
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
[MSG:Caution: Unlocked]
ok
<Idle|WPos:0.000,0.000,0.000|FS:0,0|WCO:0.000,0.000,0.000>

Payson

2023-06-06

This means you’re asking the machine to run something that will put it past the machine’s understanding of its boundaries.
If you’re not already, I’d suggest you use Absolute Coords as your start from mode in Laser window. Also, make sure you never move the laser module by hand after it’s been homed. Use jogging controls in Move window or on the machine exclusively. Movement done by hand is not tracked by the machine and it will not have awareness of its actual position.

Xem bản dịch

Trả lời

Đề xuất liên quan