chanelink logo
CHANELINK
Tiếng Việt

New to lightburn and dont know how i would engrave this

Danh mục:
Laser
Thẻ:
933
1
Xem bản dịch
2023-05-24

how should one go about making outlines? so for the green lines, i thought i could just use the option “fill” but that resulted in the whole picture getting engraved. i really wanna make big outlines, but i dont know how to do it.
C

    • Keegan

      2023-05-25
      Put the inner and outer shapes representing the outline on the same layer and use fill.
        Xem bản dịch
        Trả lời
      Đề xuất liên quan
      Thu thập
      Báo cáo