Double line cutting on atomstack M100 / E85 module

Liam

Danh mục:

Tia laze

Thẻ:

LightBurn

Xem bản dịch

2023-05-24

Hello everyone, I am having a double-line issue. I have already adjusted both axis, but the problem persists.-
What i find strange is that all the double lines go in the same way, and they al seem perfectly cut and seems like a pattern and not linke an error.
Any advises? Is it a harware issue?
Thank you all in advance.

Keegan

2023-05-25

How have you done this?
To me it looks like you may be missing steps on the X-axis. Check belt tension and make sure you’re not skipping the belt. Also check that the pinion gear is properly secured to the stepper shaft.

Xem bản dịch

Trả lời

Đề xuất liên quan