Missed lines in hatch fill

Nugent

Danh mục:

Tia laze

Thẻ:

LightBurn

377

Xem bản dịch

2023-03-09

When I am engraving, I notice that there are missed lines in the text that have not been engraved, they follow the hatch direction. I also use crosshatch and it is still there. I engrave stainless steel and within all the text there are these silver lines. Any ideas. I used a 0.001 hatch.

Snow Sun

2023-03-10

Which software did you use? if it is RDWorksV8, it should be not happend with such situation. just se the hatch interval correctly in the layer parameter and set the mode to be scan mode.
if it is LB, you can set 0.02 or more to check.

Xem bản dịch

Trả lời

Đề xuất liên quan