How to select the control system of laser marking machine

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov

After normal connection, press the auto-focus button, and the cutting head will move upward all the time.

The cutting head does not lift up and down, but the motor has sound.

After cutting, it is found that the graphics in the software and the actual graphics are reversed from left to right or up to down.

The cutting drawing is not closed, and there is no problem with the drawing. How to solve this problem?

It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?

It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.

The border running is normal, but the click to start does not respond.

The layer ordering is not valid.

The processing serial number arrangement is invalid.

I am not familiar with the software, how to set the starting point and direction of cutting?

6563F moves manually on the panel according to Z-axis, and the cutting head does not move.

When RDC6563F is used, XY axis does not move manually

XY axis does not reset

During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.

Switch to the manual state, press the Z+and Z - buttons on the operation panel, and the Z-axis motor will not move

When pressing Z - or Z+for a longer time (about 3-4S), the Z axis will go down or up all the time, and it is normal to press Z - or Z+for a shorter time.

Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y

The panel did not prompt hard limit protection when Z-axis reached the hard limit switch