Operation steps for collecting signals on the table of the vibration knife control system

The operation steps for signal collection on the vibration knife control system (RDD6584G, RDD6616U, ) are as follows:

1. Preparation:

   Ensure the vibration knife control system is properly connected, with the signal interface as D+.
   Check the physical connection between the device and the signal collection equipment to ensure there are no connection issues.

2. Set the margin:

   Before starting the surface collection, set the margin appropriately based on actual requirements. Proper margin settings help the system accurately control the collection area and avoid errors.

3. Enter debug mode:

   On the control system interface, enter the "debug" mode. Select the "Other" option via the touch screen or control panel.

4. Select surface collection:

   In the "Other" settings, find and select the "Surface Collection" function.

5. Set the collection spacing:

   In the surface collection settings interface, adjust the collection spacing based on the processing needs. Generally, smaller spacing improves collection accuracy but increases processing time.

6. Start collection:

   After confirming all parameters are correct, press the start collection button, and the system will begin automatically collecting surface signals.

7. Check and save data:

   After collection is complete, the system will display the results. Check if the data meets expectations. If there are any discrepancies, you can readjust the parameters and collect again.