chanelink logo
CHANELINK
Türkçe

Not Marking

Kategoriler:
Lazer
Etiketler:
999
1
Çeviriyi gör
2023-02-24

I have MP-30 LiteMarker 30W Split Laser Engraver… I have EZCAD 2 and have installed the driver just fine. I have adjusted the focus. I have used the EZCAD 2 that was shipped with the laser.
C

    • Payson

      2023-02-27
      1. Check if all buttons are turned on
2. Check whether the driver is connected correctly
3. Check parameter settings, output or fill
4. Turn the rotary wheel up and down to check whether there is laser emission
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor