chanelink logo
CHANELINK
Türkçe

How to set the cutting of 15mm and 18mm plywood?

Kategoriler:
Lazer
Etiketler:
485
3
Çeviriyi gör
10-11
I want to cut 15 mm and 18 mm plywood with my laser. Iv not been able to find the right speed and power to cut thru 15 mm and 18 mm plywoods.
please help and tell what power and speed should I set to trhu these thicknesses without harming my laser.
C

    • Henry

      10-13
      Try a test cut at speeds 5 - 15 MM/Sec at 85-90% pwr
        Çeviriyi gör
        Yanıtla

      • Nugent

        10-15
        If your focal length is short (2 inches or at worst 1.5 inches), it will be very difficult or even impossible, as there is no way to obtain a sufficiently narrow 'burning point' across the entire height of the material.
By using a focal length of 2.5 inches or 4 inches, you can achieve results, but you must slow down and have a powerful air assist to blow away dust on the cutting path.
          Çeviriyi gör
          Yanıtla

        • Smith

          10-16
          Plywood can be composed of almost any combination of wood/adhesive layers. Some are easy to cut, some are almost impossible
            Çeviriyi gör
            Yanıtla
          İlgili öneriler
          Topla
          Rapor