chanelink logo
CHANELINK
Türkçe

Laser cutting of acrylic with rough edges

Kategoriler:
원자 램프
Etiketler:
350
1
Çeviriyi gör
09-29
Hello, I am cutting extruded acrylic and the edges are very rough and appear to have little bubbles through out it. I've cut this stuff before with a great flame polished finish. Any advice on why this is happening?
C

    • Williams

      09-30
      Have you tried lowering the amount of air assist you are using? Too much and it will cool the cutting zone.
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor