Randomization of material testing sequence

Iron Man

Kategoriler:

Lazer

829

Çeviriyi gör

2024-10-16

Is there any way to randomise the order of the shapes burned in the material test? The localised heat effects of ramping power/frequency/speed in the x axis tend to give unreproducible results when these are taken into consideration. I have tried putting a 0% sublayer in to reduce this, but it makes the time to run a test significantly longer.
Stainless steel and Titanium especially so.
Essentially, I want the antithesis of optimise settings. Give me the biggest distance possible between material test squares!

Payson

2024-10-17

There is not, no.
It always burns “coolest to hottest” because on diode or dsp lasers if the range is going to end up “too hot” we want it to get there last, so you can stop it as soon as a cut goes through.

Çeviriyi gör

Yanıtla

İlgili öneriler